Advertisement
Split Mounting
1)
Detach Head from Mounting Bracket by removing bolt. Unwrap or otherwise free
Head Cable.
2)
Attach pipe clamp or surface mounting device to large hole in Luminaire Yoke.
(The hole is 0.4 inch in diameter and will accommodate a maximum bolt size of 3/
8 inch.)
3)
Mount Luminaire to pipe or surface using clamp or mounting device (attached in
previous step). Adjust Yoke and Head positions as desired.
cooling fins are not blocked!
4)
Attach pipe clamp or surface mounting device to large hole in Mounting Bracket.
(The hole is 1/2 inch in diameter and will accommodate a maximum bolt size of 1/
2 inch.)
5)
Mount Power Supply to pipe or surface using clamp or mounting device (attached
in previous step).
6)
Attach Safety Cable to both components as shown in Figure 3.
WARNING: A Safety Cable MUST be used for all hanging installations and may
be required by local codes.
Note: Clamps and Pipe not included.
Clamp
Yoke
Pipe
Single Head
Power Supply
Head Cable
Head
Figure 3: Split Mounting Example
4
CAUTION: Be sure
Screw (2)
Mounting Bracket
Note: Example installation.
Individual configurations may vary
AC Power Cord
Advertisement
