PRG Bullet Series 2.0 Quick Start Manual

Bullet Series 2.0 LED Luminaire
QUICK START GUIDE
This document provides installation and setup procedures for the PRG Bullet Series
2.0 LED Luminaire.
For complete operating instructions, refer to the Bullet Series 2.0 LED Luminaire User
Manual available at
For technical assistance, contact PRG RH+A.
PRG RH+A
539 Temple Hill Road
New Windsor, NY 12553-5533
1-800-748-6562
www.prg.com
1. IMPORTANT SAFETY INSTRUCTIONS
+
Keep these instructions.
+
Heed all warnings.
+
Follow all instructions.
+
Do not block any of the fixture's ventilation openings.
+
Do not operate at temperatures above 40°C (104°F).
+
Do not install the fixture near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
+
Do not install the fixture on or near a flammable surface.
+
Do not operate the fixture with a damaged power lead. If the power lead (cordset)
is damaged, it must be replaced.
+
Do not operate the fixture if lens is deeply scratched or cracked. Damaged lenses
must be replaced.
+
Mount and support the fixture only by the primary suspension holes in the yoke.
+
Suspend the fixture from a suitable structure using only hardware rated for the
weight of the fixture.
+
In addition to primary suspension, attach a safety cable to the fixture housing. An
appropriate attachment point (hole) is provided in the fixture's housing.
+
Disconnect the fixture from power and DMX control and allow to cool before
performing any cleaning or maintenance.
WARNING: The UV Bullet has a peak output of 365nm, which is in the
Ultraviolet A (UVA) range. Ultraviolet (UV) light is harmful to the skin and eyes.
Since it is minimally visible to the naked eye, this hazard is more significant. DO
NOT stare directly into the lens when testing or operating the unit. Avoid long-
term exposure to the UV light at close range unless appropriate precautions are
taken to block the harmful wavelengths.
www.prg.com
1