Advertisement
3.
INSTALLATION
Unified Mounting
1)
Attach pipe clamp or surface mounting device to large hole in Mounting Bracket.
(The hole is 1/2 inch in diameter and will accommodate a maximum bolt size of 1/
2 inch.)
2)
Mount Luminaire and Power Supply to pipe or surface using clamp or mounting
device (attached in previous step). Adjust Yoke and Head positions as desired.
CAUTION: Be sure cooling fins are not blocked!
3)
Attach Safety Cable as shown in Figure 2.
WARNING: A Safety Cable MUST be used for all hanging installations and may
be required by local codes.
Clamp
Mounting Bracket
Pipe
Single Head
Power Supply
Head
Yoke
Figure 2: Unified Mounting Example
3
Note: Clamp and
Pipe not included.
Safety Cable
Head Cable
Note: Example installation.
Individual configurations may vary
AC Power Cord
Advertisement
