TecJet S Series User Manual page 36

print
Printing is not finished
9 but data transmission
ends
Empty or overlapping
10
printing
Image printing size is
11
too long or short
Bad resolution and ink
12
spitting
No ink out when
13
printing
14 Color cast
Error reports from
carriage and print
15
ends
c) cables connecting main board
and carriage board are not
connected well
a) carriage board is broken
b) there is not enough space to
install maintop
a) feeding adjustment is not good Make feeding adjustment again; change
b) media situation different from
feeding calibration and printing
a) calibration values are not
correct
a) distance between head and
media is too high( normal
1.8-2.2mm)
b) lower than 42V
c) vertical calibration and
two-way calibration is not good
d) carriage moves too fast
e) abnormal head drive plate
a) affected by interior
temperature and humidity
b) bad ink quality
c) Ink supply system is not good
d) carriage moves too fast
e) head drive plate is of problems
a) check ink and head situation of
ink out
b) less than 42V
c) abnormal head drive plate
a) 26P cables connecting not
good
b) servo motor reports errors
c) error reports from raster slip
Check cables connecting
Change new carriage board
Clean installation disk or change another
disk so that the space is big enough
different media to adjust
Adjust media feeding in system and make
media feed well
Calibrate feeding again or change values
in maintop
Adjust the distance
Check 42V power and see if it's OK
Make vertical and two-way calibration
again
Change printing speed
Change a new head drive plate
Keep temperature normal
Change good quality ink
Keep ink supply pressure normal and no
air leakage in ink tubes and connecting
parts
Change printing speed
Change new head drive plate
Ink is not matched with maintop profile or
head block
Check 42V power
Change new head drive plate
Connect them again
Check servo motor connecting
Check raster slip position and situation.
Connecting between raster slip and
circuit plate is not good. Check Encoder
21 / 24