Operation; Applications; Adding Bar And Chain Lubricant - Yardworks 054-5752-2 Instruction Manual

16
model no. 054-5752-2 | contact us: 1.866.523.5218

APPLICATIONS

You can use this product as a pole saw for the purposes listed below:
• limbing
• Pruning
You can also use this product as a chainsaw for the purposes listed below:
• Basic limbing, felling, and woodcutting
• Removing buttress roots
ADDING BAR AND CHAIN LUBRICANT (SEE FIG. 7)
Use a lubricant that is designed for chains and chain oilers, and is formulated to perform over a
wide temperature range with no dilution required.
• Remove oil cap.
• Carefully pour the bar and chain oil into the tank.
• Wipe off excess oil.
• Check and fill the oil tank when quick-view oil indicator is below the "MIN" indicator line.
• Repeat as needed.
Min
!
NOTE: The pole saw comes from the factory with no bar
and chain oil added. The level should also be checked
after every 10 minutes of use, and refilled as needed.
!
NOTE: Do not use dirty, used or otherwise contaminated
oils. Damage may occur to the bar or chain.
!
NOTE: It is normal for oil to seep from the saw when not
in use. To prevent seepage, empty the oil tank after each
use, then run for one minute. When storing the unit for a
long period of time (three months or longer), be sure the
chain is lightly lubricated. This will prevent rust on the
chain and bar sprocket.
QUICK-VIEW
OIL INDICATOR
OIL RESERVOIR
CAP
Fig. 7