Table of Contents
Advertisement
2. Remove the current DDR3L RAM module and replace it with a new one.
Image 2-5
3. Put the RAM service door back in place and fix it with the Security Torx screws.
2.4
JAOHandset installation
C
AUTION
disconnected from the power sources to prevent electric shock or system damage.
To fully disengage the power to the unit, please disconnect the power cord from the AC
inlet.
W
ARNING
JAOHandset and do not listen at high volume levels for long periods.
To switch the position of the JAOHandset (L/R)
The default mounting position of your JAOHandset is on the left hand side of your terminal. The procedure
below describes how to prepare the JAOHandset for right hand side mounting.
1. Remove the 2 caps and the screws at the inside of the handset cradle.
2. Take apart the mounting bracket from the handset cradle and rotate the bracket 180°.
3. Reassemble the handset cradle with the 2 fixation screws and reinsert the screw caps.
Image 2-6
The JAOHandset can now be attached to your terminal as described in the next procedure.
K5903250 JAO15 / JAO18 10/03/2016
:
Prior to removing any service door, make sure the unit's power is off and
:
To prevent possible hearing damage, check the volume before listening the
2. Installation
9
Advertisement
Table of Contents
