Chapter 3 Advanced Usage - Melco N1 Series Software Manual

Chapter 3 Advanced Usage

Using Direct Mode
Set the N1 to direct mode if it is directly connected to the Network Audio Player with an Ethernet cable and no other
devices are on the network. If using this mode, the N1 will not be connected to the router so it won't be able to
controlled using the app. For playback, use the Network Audio Player's display panel and remote controller to select
a music file. If a Network Audio Player is not available, it will not be able to select a music file.
To configure direct mode, follow the procedure below.
Note: Give the N1 plenty of space for airflow. Do not stack it with other devices that may give off heat.
1
Connect the N1's player port and a Network Audio Player with the provided Ethernet cable. Do not connect
the Ethernet cable to the Ethernet port for a router or hub.
2
Turn on the Network Audio Player.
3
Press the Menu/Enter button (
4
Press the Down button (
N1(Rear)
) to display the menu list at the home screen.
) and select "Settings", then press the Menu/Enter button (
Network Audio Player
29
).