Factory Presets - Dynacord L1300FD-AU Installation Manual

26 en | Power amplifier menu navigation
Notice!
Controlling multiple amplifiers via Dynacord control software: It is recommend to use a powered
USB hub if the user wishes to control amplifiers with one cable to their computer. USB range
extenders can also be used to remotely position the software control interface longer distances
from the amplifiers.
Due to the great number of USB hubs and extenders, it is not possible to verify and test all
brands and models for use with this product.
To find current user documentation, firmware, or software visit our product related
information at www.dynacord.com.
7.3

Factory presets

L Series and C Series amplifiers have a selection of factory presets on board. These are
generic settings to be used as a starting point for configuration that do not require a
dedicated speaker setting, but only some basic sound adjustments. The following content is
based on the first release, future firmware updates might include additional or updated
settings.
F01
F02
F03
F04
F05
F06
F07
F08
F09
F10
Table 7.2: L Series factory presets
F01
F02
F03
F04
F05
F06
F07
C1300FDi
2017.10 | 02 | F.01U.327.801
Name Input Routing
Linear Dual In A > Out A
Linear Mono A In A > Out A
Stereo Linked In A > Out A
Sub & Top #1 In A > Out A
Sub Stereo #1 In A > Out A
Top Stereo #1 In A > Out A
Sub & Top #2 In A > Out A
Sub Stereo #2 In A > Out A
Top Stereo #2 In A > Out A
LPN Stereo In A > Out A
Name Input Routing
Linear Dual In A > Out A
Linear Mono A In A > Out A
Stereo Linked In A > Out A
HP50Hz-Dual In A > Out A
HP50Hz-Mono In A > Out A
HP50Hz-Stereo In A > Out A
LPN Stereo In A > Out A
Installation manual
L Series and C Series FIR-Drive Power
Parameters
In B >Out B All flat, no links
In A >Out B All flat, no links
In B >Out B All flat, CH A & B linked
In A > Out B BW18dB x-over @ 100Hz
In B >Out B BW18dB Lo-Pass @ 100Hz
In B > Out B BW18dB Hi-Pass @ 100Hz
In A > Out B LR24dB x-over @ 100Hz
In B > Out B LR24dB Lo-Pass@ 100Hz
In B > Out B LR24dB Hi-Pass @ 100Hz
In B > Out B LPN filter for enhanced LF
Parameters
In B >Out B All flat, no links
In A >Out B All flat, no links
In B >Out B All flat, CH A & B linked
In B >Out B Hi-Pass 18dB @ 50Hz
In A >Out B Hi-Pass 18dB @ 50Hz
In B >Out B Hi-Pass 18dB @ 50Hz, CH A &
B linked
In B >Out B LPN filter for enhanced LF
Bosch Sicherheitssysteme GmbH
Amplifiers