Step 1 - Convert The Pressure Regulator - Bosch NGM5456UC Installation Manual

Step 1 - Convert the pressure regulator

Locate the pressure regulator on the bottom right end of
the cooktop.
Note: The arrow on the back of the regulator must point
in the direction of the gas flow to the cooktop.
Remove the hexagon shaped cap from the regulator
1.
making sure not to dislodge the gasket on the cap or
the spring inside the regulator.
Grasp the plastic button stem firmly and pull it
2.
forcefully from the metal cap. The stem snaps snugly
into an indent in the cap and may require a strong pull
to remove. (Hint: it may be helpful to gently "rock" the
plastic stem while pulling it from the metal cap.)
Spring
A
Plastic button stem
B
Gasket
C
6
After removing the stem from the cap, rotate the stem
3.
180° so the button end of the stem is away from the
cap and the letters "LP" on the stem are upside down
when the cap is set flat on its head. Snap the stem
back in place in this position inserting it into the indent
in the metal cap.The stem should snap into place.
Important: Attach the metallic sticker (included with
4.
this conversion kit) to the bottom of the appliance as
shown, placing it near the appliance data plate (shows
model number and information about the appliance).
This sticker provides notice that the appliance has
been converted for use with LP gas.