Setting The Unattended Auto Lock Feature - Apricorn Aegis Padlock DT User Manual

Setting the Unattended Auto Lock Feature

To protect against unauthorized access if the drive is unlocked and unattended, the
Aegis Padlock DT can be set to automatically lock after a pre-set amount of time.
In its default state, the Aegis Padlock Unattended Auto Lock feature is turned off.
The Unattended Auto Lock can be set to activate after 5, 10 or 20 minutes.
To set the Unattended Auto Lock please use the following steps:
1. Enter the Admin mode by pressing and holding UNLOCK + 0 for five seconds
until the LED flashes RED. This indicates that you can enter the Admin PIN.
2. Enter the Admin PIN and press UNLOCK. The drive is in Admin Mode when
the LED has changed to solid BLUE.
3. Once in Admin mode, press UNLOCK + 6. The LED should start flashing
RED and BLUE
4. Press one of the numbers below that corresponds to amount of time you
would like the drive to lock after no activity:
Auto Lock Timeout Table:
1 = 5 min
2 = 10 min
3 = 20 min
0 = OFF
The default is 0 (OFF)
5. After you have input the number, the LED should flash
indicate that you have successfully set the Unattended Auto Lock feature.
intermittently.
www.apricorn.com
GREEN
3 times to
13