Pin Management - Apricorn Aegis Padlock DT User Manual

PIN Management

This section provides information about managing your PIN in the Admin Mode and
User Mode.
Changing the Admin PIN
You can change the Admin PIN by doing the following:
1. Enter Admin Mode (UNLOCK + 0 for five seconds. Enter Admin PIN and press
UNLOCK).
2. Press and hold UNLOCK + 9 until the LED turns to Solid
GREEN.
3. Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits
and a maximum of 16 digits). The LED flashes
to Solid BLUE
4. Re-enter the new Admin PIN and press UNLOCK. The LED stays solid
for two seconds and then solid
changed successfully.
Note: If the LED flashes
less than 7 digits or more than 16 digits. Enter a PIN that contains 7 – 16
digits after the LED flashes
1.
If the LED flashes
go back to step 3. This is due to one of the following conditions:
•
•
2.
If no activity is detected within two minutes in the Admin Mode, the
Aegis Padlock DT will return to the Standby Mode.
and Blinking GREEN.
RED
RED
You waited longer than ten seconds before entering a PIN.
The new PIN was entered incorrectly.
GREEN
BLUE
indicating that the Admin PIN has been
three times, this indicates that the PIN is
BLUE intermittently.
intermittently and then
www.apricorn.com
BLUE
and Blinking
three times, then returns
GREEN
BLUE
intermittently,
11