Adding A New User Pin - Apricorn Aegis Padlock DT User Manual

Adding a new User PIN

1. Enter the Admin Mode (UNLOCK + 0 for five seconds. Enter Admin PIN and
press UNLOCK).
2. Press and hold UNLOCK + 1 until the LED turns to Solid
3. Enter a User PIN and press UNLOCK (a minimum of 7 digits and a maximum of
16 digits). The LED flashes
Blinking GREEN.
4. Re-enter the new User PIN and press UNLOCK. If the LED stays solid
for two seconds and then solid BLUE, the User PIN was successfully added.
Deleting the User PINs
You can delete all User PINs by doing the following:
1. Enter the Admin Mode (UNLOCK + 0 for five seconds. Enter Admin PIN and
press UNLOCK).
2. Press and hold 7 + 8 + UNLOCK for five seconds until the LED flashes
GREEN
three times and then changes to
3. Press and hold 7 + 8 + UNLOCK a second time for five seconds until the
LED goes on solid
this indicates that the User PINs were deleted successfully.
Changing the User PIN
1. Unlock the drive by inputting your User PIN and pressing the UNLOCK button.
2. Press and hold UNLOCK + 1 until the LED flashes RED.
3. Enter your current PIN and press UNLOCK.
The LED will be Solid
4. Enter the new PIN and press UNLOCK (The PIN must be a minimum of 7 digits
and a maximum of 16 digits). The LED will flash
to Solid BLUE
5. Re-enter the new User PIN and press UNLOCK. The LED stays solid
indicating that the User PIN has been changed successfully.
GREEN
GREEN for two seconds and then back to solid BLUE,
BLUE and Solid GREEN.
and Blinking GREEN.
www.apricorn.com
three times, then returns to Solid
BLUE RED
/
GREEN
BLUE and Blinking GREEN.
BLUE
alternating.
three times, then returns
GREEN
and
GREEN
12