Advertisement
Installation – Wall Mount Suite
Because of the design characteristics of the Wall Mounted Vanity, Wellborn recommends installation strictly in
accordance with the enclosed illustration. Failure to strictly follow the installation illustration may result in an unintended
separation of the Vanity from the wall and potentially cause injury or damage to property. Any such damage to the
Vanity caused by an installation not strictly adhering to the enclosed illustration is not covered by our warranty.
1. Draw lines at the determined mounting
height. Place another 6" below and parallel
to the previous line.
4. Insert the 2 x 6 into the notched
area. The 2 x 6 must be secured with a
minimum of (2) 3" screws (not included)
and construction adhesive on each stud.
Once secured the stud should be flush
with the face of the 2 x 6.
7. Set vanity on ledge strip and secure metal bracket to the 2 x 6 by using 1/4" x 3"
lag bolts (not included). Vanities that join a side wall must be attached by 3" screws
(not included) into the studs. Cabinets that do not require a hanging bracket must
be secured to an adjacent cabinet or wall.
32
2. Using the previous lines as guidelines,
cut out and remove the 6" strip of drywall.
Length of the opening is determined by
the width of the cabinet combined with
the distance to the wall stud in each
direction.
5. Replace removed portion of drywall.
3. Place the 2 x 6 in the removed section of
drywall, using it to draw guidelines on the
face of the studs which will be the top and
bottom of the notch. A circular saw should
be used to make two cuts to the proper
depth (1.5" on the studs, plus the thickness
of the drywall). Additional cuts in between
these cuts may be needed to make it easier
to remove the excess. Once the excess is
removed the notches may need cleaning
with a wood chisel.
6. The ledger strip should be cut 2" less than
run length of the cabinets. Place in center of
run length, securing to studs using 3" screws
(not included).
Advertisement
