Advertisement
VI. HINGE F – C2191, C2192
1. Height Adjustment: The cam screw (screw #1) moves the door up and down, just
turn to adjust.
2. Side Adjustment: Turn side adjustment screw (screw #2) until door is in proper
position.
3. Depth Adjustment: Loosen fixing screw (screw #3) and move door to desired
position, retighten fixing screw. The cam screw (screw #4) allows for additional
depth adjustment if necessary.
4. Door Removal: To remove hinge from mounting plate, pull up on locking clip (#5).
To attach the door, slide the hinge into the mounting plate track and press firmly
until a "click" is heard.
VII. HINGE G – C1087
1. Height Adjustment: Rotate cam screw on mounting plate to adjust door position
(±2 mm). On non-cam mounting plates, loosen screws, adjust door and
retighten screws.
2. Side adjustment: Rotate front screw to increase or decrease door overlay (±2 mm).
3. Depth adjustment: Rotate rear spiral tech cam screw to adjust door gap
(+3 mm, -2 mm).
VIII. HINGE H – C2197, C2200 AND C2201
1. Horizontal Adjustment: Loosen all hinge attachment screws
on the back of the door. Adjust the door to the desired position.
Tighten the hinge attachment screws and check fit. Repeat if
necessary.
2. Vertical Adjustment: Loosen all hinge attachment screws on
the inside of the cabinet frame. Adjust the door to the desired
position. Tighten the hinge attachment screws and check fit.
Repeat if necessary.
20
F
3
2
4
5
1
G
2
3
1
Advertisement
