Table of Contents
Advertisement
Controller Fault
8 Controller Fault
8.1
Fault Code Diagnostic Table
Error Code Explanation
Temperature sensor failure
S.br
9 Glossary of Terms
Home display
PID
Parameter
Segment
Program
Measured
temperature
Setpoint
temperature (SP)
Program setpoint
temperature (PSP)
Reset
Holdback
Ramp
Rate
Time
Step
Dwell
Wait
Call
End
SafeOp
Element
Thermocouple
Furnace or Oven
22
The first display of the controller screen, to which it returns when no
keys are pressed.
Proportional, Integral, Derivative: the control system used by the
controller.
A temperature or time value, or program action.
A program section in which a group of parameters are set.
A pre-set sequence of segments to control temperature changes
and time periods.
The actual temperature of the furnace or oven.
The target temperature when operating as a controller.
The target temperature as a program proceeds.
A single action by the operator to stop a program running and return
to simple controller mode.
Holdback can be used to prevent the PSP from running ahead of the
actual heating or cooling.
The Program Setpoint temperature rises or falls over a period of
time.
The rate; in degrees per second, min or hour, of the Program
Setpoint temperature rise or fall.
A set time period for the Program Setpoint temperature to rise or fall.
An immediate rise or fall in the Program Setpoint temperature.
Time period during which the PSP is fixed.
The program waits until a selected external parameter has been
met.
Interrupts a program to run another program, then returns to
continue
A segment type to end a program by either: Going into Reset and
controlling to the SP; Dwelling at the last PSP value until Reset is
pressed; SafeOp
Turns the power off.
The heating device used in the furnace or oven.
The temperature sensing device used in the furnace or oven.
This refers to the product purchased from Carbolite Gero.
Actions
Replace the Furnace or Oven
Temperature Sensor
MC19-1.22
Advertisement
Table of Contents
