Advertisement
Available languages
Available languages
Assembly
Note: The correct position for the elbow
point down (
1. Elbow: Press into the retaining ring
2. Cushion: Push onto the back of the elbow
Note: The elbow, frame and cushion will fit tightly together without any gaps
gaps or the cushion angle is low
securely on the elbow with the pillows at an angle towards the nose
3. Frame: Position the frame with the retaining ring
4. Headgear: Position the tube management loop
5. Slide the frame tabs through the headgear slots and fold forward.
Note: The Philips Respironics logo is on the outside of the headgear back strap
correctly assembled.
Philips Respironics System One Resistance Control
Your mask when combined with a Philips Respironics System One device, provides optimal
resistance compensation. This value is identified below and should be set by your provider.
Size
Setting
S, M, L
X2
Notes:
• Compare the mask to the device. See your device manual if the values do not match.
• System One is not compatible with masks that use a separate exhalation device.
Specifications
Warning: The technical specifications of the mask are provided for your healthcare
professional to determine if it is compatible with your CPAP or bi-level therapy device. If used
outside these specifications, or if used with incompatible devices, the mask may be
uncomfortable, the seal of the mask may not be effective, optimum therapy may not be
achieved, disconnect alarms may not be detected, and leak, or variation in the rate of leak, may
affect device function. The pressure flow curve shown below is an approximation of expected
performance. Exact measurements may vary.
Pressure Flow Curve
Resistance (cm H
2
Drop in Pressure at
Small
Medium
Large
)
.
Pressure cm H
O)
50 SLPM
1.4
1.3
1.2
, retaining ring
D
until all sides are flush.
.
remove the cushion and reattach. The cushion should fit
pointing down (
E
on top.
L
O
2
100 SLPM
5.5
5.0
4.4
5
, and cushion platform
E
.
).
is to
C
. If there are
when
J
Advertisement
