How To Use; Attaching Frames - Black & Decker HGS200 Series Use And Care Manual

HOW TO U SE
This product is for household use only.
G E T T ING STARTE D
• Remove all labels, tags and stickers attached to the body, or cord of the
steamer and the plastic band around the power plug.
• Remove and save literature.
• Read all the instructions before using your steamer.
IMP O RTAN T NOTE S
• Using distilled, purified, or filtered water is highly recommended to maintain
optimal performance. Tap water contains minerals that build up over time.
• Any water droplets visible inside the tank are from individual quality
control tests done to ensure every steamer meets our high standards for
product performance.
• Do not use perfumes, oils, or other additives.
• Always review the garment manufacturer's care label instructions before
steaming, and always test fabrics for colorfastness in inconspicuous
areas (such as an inseam). Steamers are not recommended for use on
leather, suede, vinyl, plastic, or other steam sensitive fabrics.
• During use the steamer and accessories will become hot. Avoid
attaching or removing frames while still hot.
• After preheating, prime water pump by holding the steam trigger until
steam forms.
• It is normal to feel or hear the water pump in the handle.
• The water pump may become louder when the water level in the tank is
low. Check and refill tank, as needed.

ATTACHING FRAMES

The steamer comes with three optional-use attachment
frames recommended for use with a variety of fabrics and
upholstery.
1. Select the proper frame using the following chart.
2. While the frame and steamer are cool, gently attach
the top of the frame over the top the steamer head and
then click the bottom of the frame into place. (A)
Note: Frame tab points down when in correct position.
3. Allow steamer to cool prior to removing frame. Gently
pull on the tab. (B)
Note: Be careful when removing frames as condensation
may build up during use.
5
A
B