Table of Contents
Advertisement
20
www.electrolux.com
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
1
Install the shelf supports in the opposite
sequence.
11.3 Catalysis
Remove all accessories and removable
shelf supports.
The walls with a catalytic coating are
self-cleaning. They absorb fat which
collects on the walls while the appliance
operates.
The catalytic cleaning
procedure cannot start:
• If you do not remove the
• if you did not fully close
Spots or discolouration of
the catalytic surface have no
effect on catalytic properties.
During the catalytic cleaning the oven
lamp is on.
1. In the main menu select the
function:Catalysis
2. Press
The display shows the time of day and
the duration of the cleaning procedure (1
hour). You cannot change the duration,
but you can delay the start of the
cleaning procedure with the function:
End Time.
When the oven is at the set
temperature, the door locks.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2
shelf support or
telescopic shelf runners
(if present).
the oven door.
to confirm.
3. Touch a sensor field or open the
oven door to stop the signal.
4. Wipe the bottom of the appliance
with a soft and moist sponge.
11.4 Removing and installing
the door
You can remove the door to clean it.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
3. Close the door until it is at an angle
of approximately 45°.
45°
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the door. Do the above steps in the
opposite sequence.
A
Advertisement
Table of Contents
