Parts Description - Makita DLS110 Instruction Manual

19. Do not leave the wireless unit in a place where
static electricity or electrical noise could be
generated.
20. Do not leave the wireless unit in a place sub-
ject to high heat, such as a car sitting in the
sun.
21. Do not leave the wireless unit in a dusty or
powdery place or in a place corrosive gas
could be generated.
22. Sudden change of the temperature may bedew
the wireless unit. Do not use the wireless unit
until the dew is completely dried.
23. When cleaning the wireless unit, gently wipe
with a dry soft cloth. Do not use benzine, thin-
ner, conductive grease or the like.

PARTS DESCRIPTION

1 Slide pole
5 Holder
9 Kerf board
13 Blade guard
Adjusting bolt (for maxi-
17
mum cutting capacity)
21 Releasing lever
(for turn base)
16 19
17
18
10
1
2
3
4
5
6
2 Stopper pin
(for carriage sliding)
Turn base
6
10 Blade case
14 Knob (for bevel angle)
18 Stopper arm
22 Grip (for turn base)
24. When storing the wireless unit, keep it in the
supplied case or a static-free container.
25. Do not insert any devices other than Makita
wireless unit into the slot on the tool.
26. Do not use the tool with the lid of the slot dam-
aged. Water, dust, and dirt come into the slot may
cause malfunction.
27. Do not pull and/or twist the lid of the slot more
than necessary. Restore the lid if it comes off
from the tool.
28. Replace the lid of the slot if it is lost or
damaged.
SAVE THESE INSTRUCTIONS.
13
7 8 9
3 Vertical vise
7 Pointer (for miter angle)
Adjusting screw
11
(for laser line)
15 Hex wrench
19 Battery cartridge
-
8 ENGLISH
11
12
14
15
21
4 Releasing button
(for right side bevel angle)
8 Miter angle scale
Range adjustment screw
12
(for laser line)
Adjusting screw
16
(for lower limit position)
20 Lock lever (for turn base)
- -
20
22
-