Removing The Blade; Installing The Blade - Makita DLS110 Instruction Manual

Removing the blade

Loosen the hex bolt holding the center cover using the
hex wrench. Raise the blade guard and center cover.
1
2
► 1 . Center cover 2. Hex wrench 3. Blade guard
Press the shaft lock to lock the spindle and use the hex
wrench to loosen the hex socket bolt. Then remove the
hex socket bolt, outer flange and blade.
2
4
5
► 1 . Shaft lock 2. Hex wrench 3. Hex socket bolt (left-
handed) 4. Loosen 5. Tighten
3
1
3

Installing the blade

Mount the blade carefully onto the spindle, making
sure that the direction of the arrow on the surface of the
blade matches the direction of the arrow on the blade
case.
► 1 . Arrow on the blade case 2. Arrow on the blade
Install the outer flange and hex socket bolt. Tighten the
hex socket bolt counterclockwise using the hex wrench
while pressing the shaft lock.
1 2
► 1 . Hex socket bolt 2. Outer flange 3. Saw blade
4. Inner flange 5. Spindle 6. Ring
If the inner flange is removed, be sure to
NOTICE:
install it on the spindle with its protrusion facing away
from the blade. If the flange is installed incorrectly, the
flange will rub against the machine.
Return the blade guard and center cover to its original
position. Then tighten the hex bolt clockwise to secure
the center cover. Unlock the stopper pin to release
carriage from the raised position. Lower the handle to
make sure that the blade guard moves properly. Make
sure shaft lock has released spindle before making cut.
WARNING:
the spindle, always be sure that the correct ring
for the blade's arbor hole you intend to use is
installed between the inner and the outer flanges.
Use of the incorrect arbor hole ring may result in the
improper mounting of the blade causing blade move-
ment and severe vibration resulting in possible loss
of control during operation and in serious personal
injury.
19 ENGLISH
3 4
6
Before mounting the blade onto
1
2
5