Transfer Of All Memorized Measurements And Reset Of Memory - Metro DataVac DPC 20 User Manual

MANOMETER DPC 20
Example 1)
Command
00CrLf or 0CrLf
12CrLf
25CrLf
If sample size > 0, the manometer will transfer the value of measurement number n
provided it has been recorded, otherwise an error message will be transferred.
Example 2) : sample size was set to 10 and only 6 measurements have been
recorded.
Command
00CrLf or 0CrLf
05CrLf or 5CrLf
08CrLf or 8CrLf
12CrLf

5.2.2 Transfer of all memorized measurements and reset of memory

Command: SCrLf
When receiving this command, the manometer will transfer all measurements one
after the other, separated by a delay of one second. Then the memory is reset.
Examples:
1) Sample size was set to 4 and 4 measurements have been recorded:
SCrLf
The parameter « Unit » can assume one of the following values:
0 : Bar
3 : mH
After this operation, the memory of the manometer is empty !
2) Sample size was set to 4, but no measurement has yet been recorded:
3) Sample size was set to 0. Consequently, no measurement has been recorded:
HOW TO USE THE SERIAL LINK
00:+05.26_unitCrLf (displayed value)
12:+11.31_unitCrLf (recorded value)
25:******CrLf (maxi value = 20)
00:+05.26_unitCrLf
05:+12.30_unit CrLf (recorded value)
08:******CrLf (no value recorded: maxi = 6)
12:******CrLf (impossible: sample size = 10)
01:+05.36_unit CrLf
02:+05.35_unit CrLf
03:+05.37_unit CrLf
04:+05.35_unit CrLf
1 : PSI
2 : kPa
O
2
SCrLf S_:******CrLf
SCrLf S_:******CrLf
Transferred value
Transferred value
4 : kg/cm 2
5 : cm/Hg
6 : ATM
7 : tonf/ft 2
(displayed value)
(waits for one second)
(waits for one second)
(waits for one second)
Page 13