Panasonic KX-UDS124 Installation Manual page 39

The Maintenance mode main menu will be displayed.
No Service Alarm
CS Monitor
Reset Handset
Full Charge LED
Side Tone Vol
Site Survey for S-PS Service Area
1.
Place a SIP-CS in the location confirmed for the Air Sync Master CS in the previous site survey.
2.
Supply power to the SIP-CS using an AC adaptor.
3.
Start the S-PS in Maintenance mode.
(See "Starting the S-PS in Maintenance Mode", above.)
4.
Select "CS Area Check" on the S-PS.
5.
Press twice.
OK
The S-PS will be in CS Area Check mode and you will hear a tone.
6.
Walk around the SIP-CS to confirm the SIP-CS's service area.
If the radio strength level and Error Rate are at acceptable levels, you will continue hearing a tone from
the S-PS and 2 lines on the LCD of the S-PS light green.
Note
If there is an area where you cannot hear a tone and the 2 lines of the LCD do not light green, relocate
the SIP-CS.
7.
After confirming the service area, press TALK/SP-PHONE key on the S-PS to stop the tone.
8.
Relocate the SIP-CS to another location.
9.
Walk around the SIP-CS to confirm the SIP-CS's service area.
10.
Repeat steps 8 to 9 for all the locations so that the SIP-CSs will provide service for whole area.
4 Deployment Procedure
Installation Guide 39