Aluminum Foil And Oven Liners - GE CT9570 Owner's Manual

Direct air convection built-in electric 30” french door double wall oven
Table of Contents

Advertisement

Available languages

Available languages

Oven Racks (Cont.)
To Remove An Extension Rack
1. Make sure the rack is pushed all the way into the
oven.
2. Grasp the rack by both its upper front rail and its
lower handles on two sides and lift straight up to
unlock the rack from the rack supports.
3. Firmly holding onto both the upper front rail and lower
handles on both sides, pull the rack forward. Grasp the
rack on both sides if necessary. Then remove it from
the oven.
To Replace An Extension Rack
1. Place the rear portion of the rack onto the rack
supports (guides) as shown in the picture.
2. Hold the upper front rail and lower handles and push
the rack all the way in until the install feature locks
into the front rack support.
on the rack slides.
Traditional Flat Racks
The racks have stops so that when placed correctly on
the supports they will stop before coming completely out
and will not tilt. When placing and removing cookware,
pull the rack out until it stops.
To Remove a Rack
Pull it toward you, tilt the front end up and pull it out.
To Replace a Rack
Tilt the front of the rack up, hook the rear locating posts
under the rack supports, push the rack back (past the
stoppers) and lower it into position. Push the rack all the
way in.
some cooking oil on a soft cloth or paper towel and rub
onto the sides of the rack and each rack support.
CAUTION
Use caution when removing a rack from lowest position as door may be hot.

Aluminum Foil and Oven Liners

CAUTION
Do not use any type of foil or oven liner to cover the oven bottom. These items can trap heat
or melt, resulting in damage to the product and risk of shock, smoke or fire. Damage from improper use of
these items is not covered by the product warranty.
foil than necessary and never entirely cover an oven rack with aluminum foil. Keep foil at least 1-1/2" from oven walls
to prevent poor heat circulation.
10
Handle
unlock from
the rack
support
Hold the upper front rail and
lower handles and push the rack
all the way in until the install
feature locks on the front support
Rack
Support
Handle
Front
Flat Rack
Stopper
49-80788

Advertisement

Table of Contents
loading

Table of Contents