Silk'n Flash&Go Instructions For Use Manual page 14

Flash&Go offers 5 levels of energy from 1 (the lowest) to 5 (the highest), represented by 3 energy level
indicator lights:
Level 1 (lowest) - the left indicator light is steadily lit.
Level 2 - the left indicator light is steadily lit and the central indicator light is blinking.
Level 3 - both left and central indicator lights are steadily lit.
Level 4 - the left and central indicator lights are steadily lit and the right indicator light is blinking.
Level 5 (highest) - all 3 indicator lights are steadily lit.
Whenever Silk'n Flash&Go™ is turned on its energy level will automatically be reset to the lowest energy level.
Only one ENERGY LEVEL Indicator Light will be on.
To set the energy level, press the Energy Level Setting Buttons using "-" or "+" to respectively decrease or
increase the energy level.
The Skin Color Sensor
Light-based hair removal on darker skin tones can result in adverse effects such as burns, blisters, and skin color
changes (hyper- or hypo-pigmentation).
To prevent such misuse, a unique SKIN COLOR SENSOR in Silk'n Flash&Go™ measures the treated skin
complexion at the beginning of each session and occasionally during the session. If the SKIN COLOR SENSOR
detects a skin tone that is too dark for Silk'n Flash&Go™ application, the device will automatically stop emitting
pulses.
If you see no light pulse and the Skin Tone Warning Indicator Light blinks, this is an indication that your skin tone,
measured by the SKIN COLOR SENSOR, is too dark for safe application. Try using the device on a different
body part or contact the Silk'n Flash&Go™ support.
Covering skin areas
Silk'n Flash&Go™ pulses should be administered in rows, starting at one end of each row and progressing
sequentially towards the other end. This technique allows better control of skin coverage, and helps you avoid
treating the same area more than once or overlapping skin areas.
When applied to the skin, the Silk'n Flash&Go™ Treatment Surface is designed to create temporary pressure
marks on the treated area. These visible marks can be used for proper positioning of the next pulse.
Try to avoid overlapping pulses!
Do not treat the same area of skin more than once per hair removal session!
If your skin blisters or burns, STOP USE IMMEDIATELY!
12