Use, Operation - Pride i-Go Owner's Manual

V. OPERATION

6. USE, OPERATION

6.1 Use
6.1.1 Controller: It is the key component of a wheelchair. All electronics
to operate the latter are housed in it(figure 18). Usually the controller is
installed in one armrest, which is connected with motor and battery on
power box.
On/off button: this button supplies the power for the electronic
components of the control system, the control system supplies the
power to the motors of the wheelchair. Do not use the on/off button to
stop the chair unless there's an emergency situation. Otherwise it may
shorten the life of the wheelchair drive components.
Joystick: The joystick is mainly used to control the wheelchair's
movement including its speed and direction(forward, backward and left
or right etc). The futher you push the joystick from its central position,
the faster the wheelchair moves. Whenever you release the joystick, it
will automatically go back to the center and the brake will be
automatically operative to stop the wheelchair.
Horn button: The horn will sound if you press this button.
Speed Up/Down Buttons and Speedometer: After turning on the power,
the speedometer shows the current maximum speed setting. This
maximum speed setting can be adjusted through the speed up button
or speed down button by user.
Charger Socket: There are only used to this wheelchair. Do not use the
sockets to supply to other electrical equipment. Otherwise, it may
damage the wheelchair's control systerm and its E.M.C
WARNING!
If your wheelchair moves accidentally, please immediately release
the joystick so that the wheelchair will stop moving automatically
unless the joystick is out of order.
CAUTION!
If you connect any device other than the supplied battery
charger into the charger socket on the wheelchair. It could cause
permanent damage to the product.
11
ch
spe
sp
6.1
Fu
ba
an
the
ch
wi
fai
en
6.1
Th
ch
ea
Ch
■B
mo
■C
■C
■T
Th
■W
■R
into