Turn On The Devices - Panasonic WJ-NX200K Installation Manual

5 Turn on the devices

Turn on the power of the recorder
Turn on the power of the recorder. When using the recorder for the first time, register the license for the recorder. (☞ Page 27)
Step 1
Connect the provided power cord to the power cord
inlet on the rear panel of the recorder, and insert the
power plug to an outlet whose rating is as follows.
WJ-NX200K: 120 V AC, 60 Hz
→ The [OPERATE] indicator on the front of the recorder will →
light, the system check will start, and the startup window
will be displayed on the main monitor.
Important:
• Never turn off the power of the recorder during startup.
• Insert the power cord fully into the power supply terminal
so that it will not loosen or come out.
• Fix the power cord fi rmly at 15 cm to 20 cm {5-7/8 inches
to 7-7/8 inches} from the plug with the provided power cord
clamp to prevent the cable from unplugging.
How to prevent power cord
disconnection
Fix a 15 cm ~ 20 cm {5-7/8 inches ~ 7-7/8 inches} space from
the power cord connector with the attached cable clamp
passed through the clamp mount.
① Pass the cable clamp (provided) through the clamp mount.
15 cm ~ 20 cm
{5-7/8 inches ~ 7-7/8 inches}
② Tighten the power cord at 15 cm to 20 cm {5-7/8 inches
to 7-7/8 inches} from the connector and fix it to the
clamp mount.
Cut the surplus part of the cable clamp as necessary.
Cable clamp
Clamp mount
①
②
25