Grizzly H2933 Instruction Manual page 7

SECTION 2: CIRCUIT
Availability
Before installing the machine, consider the avail-
ability and proximity of the required power supply
circuit. If an existing circuit does not meet the
requirements for this machine, a new circuit must
be installed. To minimize the risk of electrocution,
fire, or equipment damage, installation work and
electrical wiring must be done by an electrican or
qualified service personnel in accordance with all
applicable codes and standards.
Electrocution,
equipment damage may
occur if machine is not
correctly grounded and
connected to the power
supply.
Full-Load Current Rating
The full-load current rating is the amperage a
machine draws at 100% of the rated output power.
On machines with multiple motors, this is the
amperage drawn by the largest motor or sum of all
motors and electrical devices that might operate
at one time during normal operations.
H2933, H2934, G0447, & G0581 Update
(Mfd. Since 1/14)
Replaces Page 13
REQUIREMENTS
fire, or
H2933
Full-Load Current Rating at 220V ...........40.6A
Full-Load Current Rating at 440V ...........20.3A
H2934 & G0447
Full-Load Current Rating at 220V ...........54.6A
Full-Load Current Rating at 440V ........... 27.3A
G0581
Full-Load Current Rating at 220V ...........70.5A
Full-Load Current Rating at 440V ...........35.3A
The full-load current is not the maximum amount
of amps that the machine will draw. If the machine
is overloaded, it will draw additional amps beyond
the full-load rating.
If the machine is overloaded for a sufficient length
of time, damage, overheating, or fire may result—
especially if connected to an undersized circuit.
To reduce the risk of these hazards, avoid over-
loading the machine during operation and make
sure it is connected to a power supply circuit that
meets the requirements in the following section.
-7-