AT&T 3B2 Maintenance Reference Manual page 339

Integral Disk Tools (idtools)
16. The program will respond as shown in Figure C-6.
If the back-up defect table is on this disk, you may choose to force
the defect map to agree with it by having 382 computer Maintenance Utilities
automatically regenerate the defect map from the back-up table.
This will remove any NEW defects that the formatter or bad block handling
found, but will put the defect map in the initial state.
Re-create defect map? [yes or no] (no)
Figure C-6. Back-up defect table response
17. Since the defect map is already built, enter
<er>.
18. The program will respond as shown in Figure C-7.
Current defects are:
cy!_
he~~~~~
l:n<J!E __
h-~~~-:~-ED 2 ~~~-
0: back-up empty 00b5020f - 00000003
1: back-up empty 00b50210 - 00000004
Next relocation sector is 5
Type 'new' to enter ALL defects,
'edit' to modify current defects,
<er> to keep current list:
Figure C-7. Defect map response
19. This defect map display should look like the one built in the defect table builder
usage example, excluding the backup empty messages that are given instead of the
cylinder, head, byte, and length counts. If there are discrepancies in the mapped
display, correct the error before continuing. Enter
<er>.
Using 382 Computer Maintenance Utilities
C-15