Troubleshooting - AGFA StudioScan II Owner's Manual

Appendix A

Troubleshooting

This appendix explains some common problems you may come across
when starting up or using your StudioScan II.
The Ready indicator on the scanner operating panel fails to
light up.
Check that you have removed the lock.
Check the scanning lamp in the scanner. If the lamp flickers,
dims, or goes off, please contact your dealer.
If the weather is very cold, leave the scanner on for several
minutes to let it warm up. Turn the power off, then
immediately on again. If both lights still go off, contact your
dealer.
The scanner or Transparency Module lamp flickers, dims, or
fails to come on.
The scanning lamp is failing or has failed and needs to be
changed. Contact your dealer.
The power indicator fails to light up.
Verify the power connection to the scanner
Check that the power switch is turned on.
If you have confirmed that there is power to the scanner, it is
likely that the scanner fuse needs to be replaced. Contact your
dealer.
Troubleshooting 29