AGFA StudioScan II Owner's Manual page 12

xii Introduction
Chapter 2, 'Installation', shows you how to set up your StudioScan
II and how to set the SCSI ID number.
Chapter 3, 'Using the scanner', tells you how to place different
originals.
Chapter 4, 'Caring for your scanner', covers general maintenance
tips for your scanner.
Appendix A, 'Troubleshooting', can be helpful when you come
across problems that you are unable to solve.
Appendix B, 'Technical information', provides specifications and
lists additional accessories available for your StudioScan II.
About the FotoLook documentation
Besides this Owner's Guide, your StudioScan II comes with a
documentation set for FotoLook. In this documentation you can find
information on how to install and use the FotoLook software.
Conventions
The following conventions are used in this guide:
Note: A note of this type gives you additional information.
Instructions are preceded by a small red square and are set in
bold.
1. Numbered steps describe the actions you must take to perform
a task.