Table of Contents
Advertisement
ATTACHING THE LEG LEVER
To use the Leg Lever (9), first attach the seat to the
resistance system (see ADJUSTING THE SEAT on
page 12). Then, attach the pulley housings to the low
pulley station (see ATTACHING THE PULLEY
9
43
HOUSINGS on the previous page). Finally, attach the
29
Short Cables (43) to the Leg Lever with two Clips (29).
29
CABLE DIAGRAM
The cable diagram shows the proper routing of the
Long Cable (42). Use the diagram to make sure that
Long Cable (42)
7
the cable has been assembled correctly. If the cable
10
has not been correctly routed, the resistance system
9
will not function properly and damage may occur. The
numbers show the correct route for the cable.
1
2
4
8
6
3
5
14
Advertisement
Table of Contents
