Indle Mode (Continuous Run); Turbo Mode; Valet Mode - Titan TS 131A Owner's Manual

IDLE MODE (CONTINUOUS RUN)
This option allows you to remove your key and leave the engine running up to the
programmed runtime
A. With the engine running, press the START button.
B. The Horn will chirp twice* and the remote starter will come on.
C. Remove the ignition key and the vehicle will stay running for the length of the
programmed runtime (15 min. default)
D. The vehicle can be shutdown anytime by holding down the START button for 3
seconds or by depressing the brake pedal.

TURBO MODE

This option allows for a cool down on turbo equipped vehicles.
A. With the engine running, press the CAR FINDER button. (Brake pedal must
not be depressed)
B. The parking lights will flash and the horn will chirp 2 times*.
C. Remove the ignition key and the engine will continue to run for approximately 2
minutes.

VALET MODE

This mode disables remote starting and bypasses the starter-disable circuit (if installed).
A. Turn the vehicle ignition key to the on position (you do not need to start the
vehicle).
B. Press and hold the button on the windshield antenna.
C. After about 5 seconds, the parking lights will flash once and you will hear 5 chips
from the vehicle's horn*.
D. Turn the ignition key to the OFF position. The LED on the antenna will come on
solid.
E. The system should now be in VALET mode.
F. To cancel VALET mode, repeat steps A and B. After 5 seconds, you will see 2
parking light flashes and the horn will chirp 2 times*.
G. The system should now be out of VALET mode.