Valet "Service" Mode - Titan ts143 Owner's Manual

VALET OR SERVICE MODE
Valet or "Service" Mode will disable the remote start and/or Titan-Secure features of the system. The
optional Lock, Unlock and Trunk Release features will still be operational. When the vehicle is to have
any "under hood" or service work done, the system must be placed into Service Mode. This feature
may also be used if a transmitter is lost, damaged, or if the system malfunctions.
ATTENTION:
TO AVOID SERIOUS INJURY, this remote start system must be set into Service Mode before any
under hood servicing is started. Service Mode will prevent the vehicle from starting while the vehicle
is being serviced. It is the sole responsibility of the vehicle's owner to place the system into Service
Mode. The manufacturer accepts no responsibility for accidental starting of the vehicle while the
vehicle is being serviced.
IGNITION ON
ENTERING SERVICE MODE:
Turn the ignition key to the On position.
Press and hold the Program Button (located on the antenna - center of windshield) for 5 seconds or
until the horn/siren (optional) honks five times.
Note: The LEDs on the antenna will turn on solid to confirm Service Mode. If the Start button is
pressed when the vehicle is in service mode, the park lights will flash slowly 3 times and the vehicle
will not start.
EXITING SERVICE MODE:
1. Turn the ignition key to the On position.
2. Press and hold the Program Button (located on the antenna - center of windshield) for 5
seconds or until the horn/siren (optional) honks two times.
Note: The LEDs on the antenna will turn off and the remote starter/security functions will be re-
enabled.
Titan Data Series TS143 Owner's Guide
5 Seconds
5