Quick Start Tutorials - Xpresense The Wag Owner's Manual

Quick Start Tutorials

We strongly recommend that you read and understand this entire manual to get the most out of
the WAG. However, the short tutorials in this section may get you going more quickly if your
effects gear matches one of the Presets we have configured for popular gear.
Tutorial 1 – General Flow
Instruction
Charge the Ring.
a. Connect the AC adapter cord into the PWR jack of
Charger, and plug the transformer into a 110 VAC
1
power outlet.
b. Insert the ring into the charger and close the lid.
Slip the Ring on the finger of your choice (Typically, the
rd
3 finger of your pick hand), adjust the band, and wait for
2
the ring to wake up (20 seconds max).
Connect an effect pedal that you want to control with the
3
WAG to the rear of the Base Unit.
Use the VALUE knob to select a preset that provides the
4
desired type of control.
START WAGGIN'!
5
Comments
A blue led will illuminate the ring when the ring is installed
properly and the ring is charging. When the Green Led at the
front of the charger illuminates, the ring is fully charged and
ready for use.
The ring goes to sleep with non use to save the battery. In
PATCH view, the cursor bar graph will move with hand
opening/closing. In RADIO CHAN view the word SIGNAL will
display if the Ring is transmitting.
Examples:
Connect PEDAL OUT to a compatible effects unit's
Expression Pedal Input.
Connect MIDI OUT to a compatible effect unit's Midi Input
jack.
See the Patch Reference – Appendix C
User's Manual
page 8