Edit A Preset Parameter - Xpresense The Wag Owner's Manual

Edit a Preset Parameter

Procedure 2. To select and change a menu item:
Instruction
Use the MENU +/- switches to navigate to the
1
desired parameter
Use the VALUE +/- switches to change the value
of the parameter
Save or Copy a Preset/Patch
You can save your edits to a Patch. You can also copy from one patch to another.
To save or copy a patch:
Instruction
Press the MENU + and VALUE – together
1
This combination is labeled on the front panel
To save to the same Patch number just press the
MENU + and VALUE – together a second time
To copy the current patch settings to another
patch: use the VALUE +/- switches to select the
destination patch number.
Press the MENU + and VALUE – together
A second time to complete the save
Restoring the Factory Patch Settings:
Instruction
Power down the Base Unit
2
Hold down MENU – and VALUE + at the same
time while powering up the base unit
Comments
The Value dial cycles through the available values for the selected
parameter. As you rest on a value, it will take effect immediately
Comments
The word SURE? Will be displayed
The word SAVING will be displayed briefly. If you press any other
switch combination you will exit the SAVE mode.
The patch number will change on the display
The word SAVING will be displayed briefly. If you press any other
switch combination you will exit the SAVE mode.
Comments
The Factory patches will be restored
User's Manual
page 18