Waking The Ring - Xpresense The Wag Owner's Manual

To recharge the WAG Ring:
Instruction
Plug the AC adapter cord into the PWR jack of the
1
Charger
Plug the AC adapter into a 110 v power outlet.
Insert the ring into the charger as shown above and
close the lid. The ring must be positioned in the
charger as shown.
Tips 'N Tricks
A short recharge of about 15 minutes can extend the use considerably.

Waking the Ring

The ring goes to sleep after about 3 minutes of non use. This will not likely happen while the
ring is mounted on your finger. The longest wake up period should be about 20 seconds after
putting the ring back on your finger. Closing your hand partially may help insure that the ring
wakes up.
Pausing/Un-pausing the Ring
If you want to temporarily discontinue using the Wag Ring you can pause the ring
communications with the Base Unit by touching the sensor area on top of the ring lid. The lid
will light up briefly to acknowledge the request. To un-pause the ring, touch the ring lid a second
time. When the ring is operating (not paused), the LEDs under the lid will flicker each time you
close your hand. When paused, the LEDs will flicker at a fixed periodic rate.
Making Connections
As shown in the following figure, the WAG Base Unit currently provides 2 interfaces to external
devices, via the rear panel. These are MIDI OUT and Pedal Out. The Pedal Out simulates a
standard 10K Expression Pedal (potentiometer). The MIDI Out sends MIDI CC and MIDI
Program Change messages.
Comments
The ring will be illuminated by a blue LED if installed properly and
charging. A green LED will light up at the front of the Charger
when the ring is fully charged and ready for use.
User's Manual
page 12