Handling And Installation - Bosch MDCI8-1 Installation Manual

4 | OUTDOOR UNIT INSTALLATION
A
B
MODEL (kW) A B C
8/10.5 990 624 380 339
12/14/16/18 1280 600 366 320
•
Single unit installation
(Wall or obstacle)
Air inlet
>300
Air inlet
Air outlet
• Parallel connection of two or more units.
>300
>600
>2000
• Parallel connection for units facing each other.
>2000 >500 >3000
6 720 874 421 (2017/04) ZA
Fig. 3-2
Fig. 3-3
D E F G H Fig.
Fig. 3-1
396 366 1073 966
Fig. 3-3
Fig. 3-2
400 360 – 1327
Fig. 3-3
Maintain
>600
channel
Fig. 3-4
Fig. 3-5
>3000 >300
Fig. 3-6

3.3 Handling and installation

• Caution must be taken when handling the outdoor unit, the
weight is not in the centre of the unit. The unit is heavier on the
front right side. For lifting advice consult HSE and use specified
lifting equipment.
• Do not touch the fan blades. The fan blades are sharp and could
cause an injury.
• When handling the unit, ensure you do not lean the unit more than
45 degrees as this will cause internal damage to the compressor.
• Fasten the feet of this unit with bolts firmly to prevent it from
toppling over. (Refer to Fig. 3-7)
Fix with bolt
NOTE
All the pictures in this manual are for illustration purposes only. The
illustrations may be slightly different from the air conditioning unit you have
purchased (dependent on model).
3.4 Condensate Outlet
There are four condense water outlets on the body of the unit shown on
the figure below.
Reserve water outlet
Remove knockout
if required
Reserve water outlet
(With rubber stopper)
CAUTION
When installing the outdoor unit, consider the drainage points.
Fig. 3-7
Outlet for power and connecting pipes
Water Outlet
Fig. 3-8
Mini VRF Heat Pump Outdoor Unit