Preparation Before Operation; To Set The Batteries - Daikin CTXU25G2V1B Operation Manual

01_EN_3P232703-1.fm Page 6 Thursday, December 18, 2008 5:51 PM

Preparation before Operation

2
Position + and
– correctly!
3
1
Receiver
Pull.
Set.
Remote
controller
holder
ATTENTION
About batteries
• When replacing the batteries, use batteries of the same type, and replace the two old batteries together.
• When the system is not used for a long time, take the batteries out.
• The batteries will last for approximately one year. If the remote controller display begins to fade and the degradation of reception
performance occurs within a year, however, replace both two batteries with new size AAA.LR03 (alkaline).
• The attached batteries are provided for the initial use of the system.
The usable period of the batteries may be short depending on the manufactured date of the air conditioner.
About remote controller
• Never expose the remote controller to direct sunlight.
• Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with soft cloth.
• Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room.
Consult the shop if that is the case.
• If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the shop.
6

To set the batteries

1.
Slide the front cover to take it off.
2.
Set two dry batteries AAA.LR03 (alkaline).
3.
Set the front cover as before.
To operate the remote controller
• To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block
signals between the unit and the remote controller, such as a curtain, the unit will not operate.
• Do not drop the remote controller. Do not get it wet.
• The maximum distance for communication is about 7m.
To fix the remote controller holder on the wall
1.
Choose a place from where the signals reach the unit.
2.
Fix the holder to a wall, a pillar, or similar location with the
screws procured locally.
3.
Place the remote controller in the remote controller holder.
Attach the titanium apatite photocatalytic air-
purifying filter and air supply filter
Turn the breaker ON
• Turning ON the breaker opens once and closes the flaps. (This is a normal procedure.)
(page 28, 29.)