Adjustment Of The X Direction - Mitsubishi PLK-G6030 Technical Manual

7-18-1. Adjustment of the X direction

(1) Turn the power switch off.
(2) The mechanical home position of the X direction is the position where the detector (No.2) can detect
the edge of the detector plate X (No.1).
(3) For the adjustment of the X direction mechanical home position, loosen the detector plate set screws
(No.3) at the left and right side then, move the detector plate X in the arrow direction as shown on the
figure. Set the clearance between the detector plate X and the detector within the range of 1.0 to
1.5mm.
(4) Turn the power switch on. Press the home position return icon
home position.
(5) If the mechanical home position is not the desired position, carry out the same procedure (3) and (4)
again. In that case, turn the power switch off each time.
[Notice] The machine has a function that the motor memorizes the home position at the first home
position returning operation after the switch is turned on. Therefore, from the second home position
returning, it does not use the home position return sensor. Make sure to turn the power switch off to
change the mechanical home position.
To use the sensor from the send returning, press
returning method since the second time returning] on the standard screen and set it ON.
<3>
<1>
<2>
>
<1>: Detector plate X
<2>: Detector
<3>: Detector plate set screw
- 31 -
, and check the mechanical
> [Home