Table of Contents
Advertisement
10. Turn on the blade server.
11. Start the blade server Configuration/Setup Utility program and set configuration
34
Eserver BladeCenter HS20 Type 8843: Installation and User's Guide
4. Open the blade server cover (see "Opening the blade server cover" on page
21 for instructions).
5. Locate the battery on the system board.
6. To remove the battery, use your finger to press down on one side of the
battery; then, slide the battery out from its socket. The spring mechanism will
push the battery out toward you as you slide it from the socket.
7. Insert the new battery:
a. Tilt the battery so that you can insert it into the socket.
b. As you slide the battery into place, press the battery down into the socket.
8. Close the blade server cover (see "Closing the blade server cover" on page
36).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
9. Reinsert the blade server into the bay in the BladeCenter unit.
parameters as needed (see "Using the Configuration/Setup Utility program" on
page 41 for information).
Battery
Advertisement
Table of Contents
