JVL FBG10 User Manual page 26

3.7
06:
07:
Ad error code 01: FBG10 is in this condition if an ID1, ID0 received from PROFIBUS
has not followed correct sequence. Error lamp will be lit in this condition. The condition
is left by next command with correct sequence.
Ad error code 02: FBG10 is in this condition if last command is not known. The condi-
tion is left by next known command.
Ad error code 05: FBG10 is in this condition if the controller has not transmitted to
PROFI232 within expected time. The condition is left by next command.
3.7.2 Format description
BYTE 3 in input data indicates which format has been used in connection with a request.
The following formats are supported:
Format=1:
Unsigned integer, ( 16 bit ). See section 4.3.1, "Unsigned integer, (word)", page 30
Format=2:
Signed integer, ( 16 bit ). See section 4.3.2, "Signed integer", page 30.
Format=3:
Long integer, ( 32 bit ). See section 4.3.3, "Long integer", page 30.
Format=4:
Floating point, ( 32 bit IEEE ). See section 4.3.4, "Floating point", page 30.
Format=5:
Binary, ( 16 bit ). See section 4.3.5, "Binary", page 31.
Format=6:
Fixed point * 1.0, ( 32 bit ). See section 4.3.6, "Fixed point * 1.0", page 31.
Format=7:
Fixed point * 10.0, ( 32 bit ). See section 4.3.7, "Fixed point * 10.0", page 32.
Format=8:
Fixed point * 100.0, ( 32 bit ). See section 4.3.8, "Fixed point * 100.0", page 32.
Format=9:
Fixed point * 1000.0, ( 32 bit ). See section 4.3.9, "Fixed point * 1000.0", page 32.
JVL Industri Elektronik A/S — User Manual — Field Bus Gateway FBG-10
Description of Input Data
Error in response from motor controller.
Other error: Master should read register ES for diagnosis.
25