Bus Termination, Profibus - JVL FBG10 User Manual

2.4

Bus Termination, PROFIBUS

DIN E 19245 requires that PROFIBUS is terminated in both ends with a resistor network
as shown below::
FBG10 does not include this network and connection to PROFIBUS should therefore
take place by means of a SUBD-connector with an integrated resistor network. This is
however only neccessary if the FBG10-unit is physically connected as the last unit on
PROFIBUS.
JVL Industri Elektronik A/S — User Manaul — Field Bus Gateway FBG-10 11