MOTO GUZZI Engine V1100 Workshop Manual page 76

Engine V1100
3.8.3. REASSEMBLY
CONNECTING RODS
Perform removal instructions in reverse order, consider the
following warnings:
•
Replace the screws upon reassembly as they are
subject to considerable stress and load.
• Assembly clearance between the bearing and crank
pin is minimum 0.022 mm (0.00087 in), maximum
0.064 mm (0.00251 in);
•
Clearance between the connecting rod shims and
crankshaft shims is 0.30 mm (0.01181 in) - 0.50 mm
(0.01968 in);
•
Tighten the bolts on the caps with a torque wrench to
the specified tightening torque.
CRANKSHAFT
•
Correctly set the
considering their assembly position (indicated by the
holes);
•
Apply Teflon tape to the two lower rear screws to avoid
oil leaks.
• Using the suitable seal tool (part no. 19.92.71.00),
install the seal on the flywheel-side flange.
•
Hold the camshaft with the suitable tool (part
14.92.73.00), and install the flange with seal.
• To complete reassembly, follow the removal procedure
in reverse order.
crankshaft support flanges
no.
ENGINE
3 - 49