Table of Contents
Advertisement
ENGINE
•
Remove the gudgeon pin.
•
Mark the piston crown on the exhaust side to ensure
correct reassembly.
•
Remove the piston.
CHECK
Checking cylinder wear:
Cylinder diameter is to be measured at three heights, turning
the dial gauge by 90°.
Make sure that the cylinders and pistons belong to the same
class (A,B,C).
CLASS SELECTION FOR CYLINDER ø UP TO ENGINE
NO. KR014485 mm (in)
CLASS A
CLASS B
92.000-92.006
92.006-92.012
(3.62204 -
(3.62227 -
3.62227)
3.62250)
CLASS SELECTION FOR PISTON ø UP TO ENGINE NO.
KR014485 mm (in)
CLASS A
CLASS B
91.954-91.960
91.960-91.966
(3.62022 -
(3.62046 -
3.62046)
3.62070)
3 - 38
CLASS SELECTION FOR CYLINDER ø UP TO
ENGINE NO. KR014486 mm (in)
CLASS C
CLASS D
92.012-92.018
92.000-92.010
(3.62250 -
3.62275)
CLASS SELECTION FOR PISTON ø UP TO ENGINE
NO. KR014486 mm (in)
CLASS C
CLASS D
91.966-91.972
91.942-91.952
(3.62070 -
3.62093)
CLASS E
92.010-92.020
(3.62204 -
(3.62243 -
3.62243)
3.62282)
CLASS E
91.952-91.962
(3.61975 -
(3.62014 -
3.62014)
3.62054)
Engine V1100
CLASS F
92.020-92.030
(3.62282 -
3.62322)
CLASS F
91.962-91.972
(3.62054 -
3.62093)
Advertisement
Table of Contents
