MOTO GUZZI Engine V1100 Workshop Manual page 71

ENGINE
3.8. CRANKSHAFT AND CONNECTING RODS
3.8.1. REMOVAL
•
Remove the heads, see REMOVING THE HEADS.
•
Remove the cylinders and pistons, see REMOVAL,
CHECK AND INSTALLATION.
•
Remove the clutch, see REMOVING THE CLUTCH.
• Remove the flywheel, see REMOVAL, CHECK AND
REASSEMBLY.
•
Remove the timing system, see REMOVING AND
REFITTING.
•
Remove the oil sump, see REMOVAL, CHECK AND
REASSEMBLY.
•
From inside the crankcase, loosen the jointing bolts (A)
and remove the connecting rods (B).
• Loosen and remove the six screws and set aside the
washers.
• Remove crankshaft flange on generator side.
•
Loosen and remove the eight screws and set aside the
washers.
3 - 44
Engine V1100