Do you have a question about the 900GTF and is the answer not in the manual?
Questions and answers
Janet Gifford
April 10, 2025
How can i use the stoves 900gtf lower fan oven manually handbook number 08 1750302
1 comments:
Mr. Anderson
April 10, 2025
To manually use the STOVES 900GTF lower fan oven:
1. Ensure the power supply is on. 2. Set the time of day on the programmer/clock if needed. 3. Remove any protective film and wash oven shelves before first use. 4. Use the control knob to select the desired temperature or function for the fan oven.
The fan oven operates independently and can be used manually unless it is programmed for automatic cooking.
Page 2
18291 01 04/11/2002 12:19 Page 2 HANK YOU FOR CHOOSING A RITISH BUILT APPLIANCE BY TOVES We hope that the following information will help you to quickly familiarise yourself with the features of the following appliance, and use it successfully and safely. Our policy is one of constant development and improvement.
Page 3
18291 01 04/11/2002 12:19 Page 3 CONTENTS This appliance must be installed in accordance with the regulations in force, and only in a well ventilated space. Read the instructions before using or installing this appliance. User’s Section ......2 - 14 Introduction .
04/11/2002 12:19 Page 4 INTRODUCTION The 900GTF is designed to fit into a In the event of a power cut standard 600 mm wide housing unit 1. Switch off the electricity supply to with a minimum internal height of 880 the appliance.
Page 5
18291 01 04/11/2002 12:19 Page 5 INTRODUCTION Ventilation The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Ensure that the kitchen is well ventilated; keep natural ventilation holes open or install a mechanical ventilation...
18291 01 04/11/2002 12:19 Page 6 MAXI GRILL Be Safe To turn on the grill The door must be when the grill the grill door, push in and turn OPEN is used. If the door is closed the grill the grill control knob clockwise to the burner will go out.
18291 01 04/11/2002 12:19 Page 7 TOP OVEN (CONVENTIONAL) The top oven is controlled by To turn on the top oven Push in and turn the control knob anti- the programmer, and can therefore clockwise to fully on (Gas Mark 9). be used even when the main oven is programmed for automatic cooking.
Page 8
18291 01 04/11/2002 12:19 Page 8 ANALOGUE PROGRAMMER / CLOCK TO SET THE TIME OF DAY MANUAL OPERATION Pull out the START TIME knob and keep To turn on the oven it pulled out as you turn the hands of 1.Turn the START TIME knob clockwise the clock to the correct time.
Page 9
18291 01 04/11/2002 12:19 Page 9 ANALOGUE PROGRAMMER / CLOCK SEMI AUTOMATIC OPERATION AUTOMATIC OPERATION Cooking starts automatically at the To set the cooking start time only 1.Turn the start time knob until the selected time, and stops automatically INDICATOR faces the required time at the end of cooking time.
18291 01 04/11/2002 12:19 Page 10 DIGITAL PROGRAMMER / CLOCK SEMI-AUTOMATIC COOKING (EXAMPLE) AUTO symbol You have started cooking a meal or dish in appears. the oven, and want to set the time for the oven to switch off. Press the 'COOK TIME' button, then use the plus and minus buttons to set the display to show the length of cooking time required.
Page 11
18291 01 04/11/2002 12:19 Page 11 DIGITAL PROGRAMMER / CLOCK SEMI-AUTOMATIC COOKING (EXAMPLE) AUTO symbol You have started cooking a meal or dish in appears. the oven, and want to set the time for the oven to switch off. Press the 'COOK TIME' button, then use the plus and minus buttons to set the display to show the length of cooking time required.
Page 12
18291 01 04/11/2002 12:19 Page 12 DIGITAL PROGRAMMER / CLOCK FULLY AUTOMATIC COOKING AUTO symbol (EXAMPLE) appears. You want to set the time for the oven to switch on, and then after the meal or dish is cooked, to switch off. Press the 'COOK TIME' button, then use the plus and minus buttons to set the display to show the length of cooking time required...
Page 13
18291 01 04/11/2002 12:19 Page 13 DIGITAL PROGRAMMER / CLOCK A(AUTO) Symbol will flash The oven will automatically switch off at 18.00 hours (6.00pm) and the alarm will sound. To switch off the alarm, press the minute minder button. MINUTE MINDER A(AUTO) symbol goes out...
18291 01 04/11/2002 12:19 Page 14 MAIN FAN OVEN There is a short delay before ignition COOKING KEEP (up to 10 seconds) and the automatic CHILDREN AWAY FROM THE VICINITY OF ignition will continue to spark for a THE OVEN short time after the burner has lit until The oven cannot be used manually the flame is established.
18291 01 04/11/2002 12:19 Page 15 CLEANING caustic pastes, abrasive Glass parts O NOT USE cleaning powders, coarse wire wool ACIA ANEL & or any hard implements, as they will UTER INNER DOOR GLASS PANELS Use a mild cream cleaner, rinse damage the surfaces.
Page 16
18291 01 04/11/2002 12:19 Page 16 CLEANING Chrome plated parts Lacquered brass parts VEN SHELVES ANDLE TRIMS ERITAGE Only use a clean cloth wrung out in VEN SHELF RUNNERS Use a moist soap pad, eg; Brillo hot soapy water. Note: Oven shelf runners can be removed for cleaning.
18291 01 04/11/2002 12:19 Page 17 INSTALLATION INSTRUCTIONS Before you start, check that your appliance is suitable for the gas supply in your house, ie; Natural Gas or LP Gas. The gas category is clearly marked on the data badge. Regulations &...
Page 18
B.S. 5440: Part 2: 1989: All rooms require an openable win- The 900GTF LP appliance is dow, or equivalent, and some rooms designed for use on Propane or will require a permanent vent as well.
Page 19
18291 01 04/11/2002 12:19 Page 19 INSTALLATION INSTRUCTIONS Do not lift the appliance by the If no gap occurs between the back door handle edge of the shelf and the wall Remove the fixing screws from the behind the unit, we recommend that polythene bag on the top of the a gap of at least 30 mm is made by appliance, but leave the appliance...
Page 20
18291 01 04/11/2002 12:19 Page 20 INSTALLATION INSTRUCTIONS Connect to the electricity supply The wires in the mains lead are This appliance must be connected by a coloured in accordance with the fol- competent person, using fixed wiring lowing code: via a Green and Yellow = Earth DOUBLE POLE SWITCHED FUSED SPUR...
Page 21
18291 01 04/11/2002 12:19 Page 21 INSTALLATION INSTRUCTIONS Connect to the gas supply 5. Rigid connections must be accessi- 1. The inlet to the appliance is ” BSP ble to disconnect for servicing. Cut ⁄ internal situated at the rear top right a 150 mm square hole in the right corner.
18291 01 04/11/2002 12:19 Page 22 INSTALLATION INSTRUCTIONS Commissioning Grill 1. The door must be open for the grill Burner aeration burners to ignite. All burners have fixed aeration and no 2. Push in the control knob and turn adjustment is possible. clockwise to the grill setting.
18291 01 04/11/2002 12:19 Page 25 FAULT FINDING FAULT FINDING ELECTRICAL SYSTEMS - CHART 1 Before commencing appliance checks, ensure that the house electrical system is correct at the outlet used for the appliance. SWITCH POWER ON TO APPLIANCE PRESS LIGHT BUTTON ON CHECK MAINS THE FACIA.
18291 01 04/11/2002 12:19 Page 34 WIRING DIAGRAM 08 17429 03 / d1267 03 Wiring Colour Code: Bk = Black, Bu = Blue, Br = Brown, Or = Orange, R = Red, W = White, Y = Yellow Front view of inner facia panel PROGRAMMER Rear view of inner facia panel PROGRAMMER...
Page 35
18291 01 04/11/2002 12:19 Page 35 SERVICING INSTRUCTIONS 3.Door glass panel(s) EFORE SERVICING ISCONNECT THE a. Open the door and insert 2 screws GAS AND ELECTRICAL SUPPLIES through the inner holes in the door FTER SERVICING HECK GAS SOUND hinge arms (to stop the door from NESS Note: The control system only allows springing up when you remove the...
Page 36
18291 01 04/11/2002 12:19 Page 36 SERVICING INSTRUCTIONS 5.Grill glass 7.FSD valve (main oven) a. Remove the grill cowl and burner a. Remove appliance from housing (2). (11). b. Looking from the front, unscrew the b. Lift up all the tabs which secure the left-hand side panel securing screws grill glass.
Page 37
18291 01 04/11/2002 12:19 Page 37 SERVICING INSTRUCTIONS 9.FSD valve (top oven) h. The injector can now be removed a. Remove appliance from housing (2). using a 4BA tube spanner. b. Looking from the front, unscrew the right-hand side panel securing 11.
Page 38
18291 01 04/11/2002 12:19 Page 38 SERVICING INSTRUCTIONS 13. Double solenoid valve 15. Logic control pcb a. Remove appliance from housing (2). a. Remove appliance from housing (2). b. Unscrew the top panel, back panel, b. Unscrew the top panel and back and right -hand securing screws and panel securing screws and lift the lift the panels clear.
Page 39
18291 01 04/11/2002 12:19 Page 39 SERVICING INSTRUCTIONS 17. Cooling fan c. From the back of the metal facia, a. Remove appliance from housing (2). pull off the 2 leads from the cutout b. Unscrew the top panel and back and unscrew its 2 securing screws.
Page 40
18291 01 04/11/2002 12:19 Page 40 SERVICING INSTRUCTIONS 22. Oven light fitting(s) 25. Single solenoid valve a. Remove appliance from housing (2). a. Remove appliance from housing (2). b. Unscrew the top panel and side b. Unscrew top, back, and left-hand panel securing screws and lift the side panel securing screws, and lift panels clear.
18291 01 04/11/2002 12:19 Page 41 SERVICING INSTRUCTIONS 28. Door frame 29. Door seal(s) a. Remove appliance from housing (2). a. Pull of the old seal. b. The inner glass panel is not secured b. Slacken the screws in the stainless to the frame and can be removed.
Need help?
Do you have a question about the 900GTF and is the answer not in the manual?
Questions and answers
How can i use the stoves 900gtf lower fan oven manually handbook number 08 1750302
To manually use the STOVES 900GTF lower fan oven:
1. Ensure the power supply is on.
2. Set the time of day on the programmer/clock if needed.
3. Remove any protective film and wash oven shelves before first use.
4. Use the control knob to select the desired temperature or function for the fan oven.
The fan oven operates independently and can be used manually unless it is programmed for automatic cooking.
This answer is automatically generated