1,2,3,4,5 Now the power of light is in your hands! In a trial using Omnilux new-U, 7 out of 10 subjects reported a visible reduction in fine To help you get started, we have put together...
The Omnilux new-U The Omnilux new-U system comprises of a treatment unit and a separate Wall Power Supply with Cord. Ventilation slots Lens cover Yellow indicator diodes CE Label PN EL1601 Manufactured by Photo Therapeutics, Inc, CA 92010 Year Month Connection 28V DC 0.57A...
Page 5
Move the switch DOWN for RED light. Move the Switch UP for INFRARED light. Move the switch to the CENTER position for OFF. Since infrared light is not visible to the eye, the Omnilux new-U has two yellow LEDs (as shown above) which light up when the device is emitting infrared light.
Page 6
The Omnilux new-U Wall Power Supply is designed to power the Omnilux new-U treatment unit. Power from the Wall Power Supply is fed to the Omnilux new-U through the flexible cord to a small coaxial connector which plugs into the socket on the rear of the Omnilux new-U.
The Omnilux new-U has been designed with both these effects in mind. The brightness and lifetime of the LEDs used in the Omnilux new-U have been carefully selected so that you can rely on it to give effective treatments.
• DO NOT use the Omnilux new-U if you are pregnant. The safety of the treatment for Contraindications pregnant women has NOT been tested, and the risk is unknown. • DO NOT use the Omnilux new-U except for the reduction of periorbital wrinkles.
• DO NOT use the Omnilux new-U if it is • ALWAYS keep the Omnilux new-U, its Wall damaged in any way. Power Supply, and cord away from heated surfaces.
You may experience erythema (mild skin redness). If it lasts longer than 24 hours, you should stop using Omnilux new-U and seek advice from a healthcare professional. Before (top) and after (bottom) the recommended course of treatments clearly demonstrating a reduction in periorbital wrinkles.
Page 11
International standards to ensure that its Some people are sensitive to light. If you are one outputs are safe for use on the skin. The outputs of these people the Omnilux new-U may not be of the Omnilux new-U are less than 1/20 of the suitable for you.
Page 12
If after 24 hours you have not experienced an adverse reaction to the infrared 2. PLUG the wall power supply into the wall light it is safe for you to use the Omnilux new-U. outlet socket. 3. PLUG the wall power supply connector into the Omnilux new-U.
Using Omnilux new-U Treatment Recommendations A full course of treatment consists of eight treatments spread over four weeks as follows: 1. Forearm test 20 minutes RED light If no adverse reaction within 24 hours, continue with test 2 2. Forearm test...
4. SWITCH the wall outlet socket on. 5. FIT patient goggles. 6. OPERATE the selector switch on the front of the Omnilux new-U to turn on the correct color LEDs for the treatment session. (See ‘Treatment Recommendations’). Before (left) and after (right) the recommended 7.
12. REMOVE the wall power • AVOID placing the Omnilux new-U unit in a supply connector dusty or dirty environment. Dirt or dust may from the Omnilux restrict the airflow through the Omnilux new-U new-U.
Outside the United States Labeling The Wall Power Supply which comes with your The label on the rear face of the Omnilux new-U Omnilux new-U is designed to operate with contains the following information: an electrical input between 90-250 Volts, at 50-60 Cycles.
Page 17
Check that the power cord and power plug are in good condition. Check that the power plug is Light flickers during Power intermittent a good fit into the Omnilux new-U socket. If the treatment problem persists, return your device to Photo Therapeutics Inc. for servicing.
Warranty PHOTO THERAPEUTICS INC. SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL, Your Omnilux new-U is warranted to be free from defect in material and workmanship for a period OR CONSEqUENTIAL DAMAGES RESULTING of one year under normal use after its original FROM THE USE OF THIS PRODUCT.
73: 75-81. When emitting its IR light output, the Omnilux 2. Takezaki I et al; ‘Ultrastructural Observations Of new-U has been classified as a CLASS 1 LED Human Skin Following Irradiation With Visible PRODUCT in accordance with the requirements Red Light-Emitting Diodes (LEDs): A Preliminary of the International standard IEC 60825-1:2001 –...
Need help?
Do you have a question about the New-U and is the answer not in the manual?
Questions and answers