Philips Illuminate Instruction Manual page 6

A. Direct Connection – In this mode communication occurs wirelessly only between your
smart device and the Illuminate™ control box. This uses a WiFi connection directly
between your smart device and the control box and not between any other devices or
routers.
◊ NOTE: While connected directly to your Illuminate™ control box using WiFi, your
internet connection will not work as you have a direct link over the WiFi connection
only between your smart device and the Illuminate™ control box.
B. Connect to local WiFi Router – In this mode communication occurs wirelessly through
your WiFi Router. In this mode the smart device and Illuminate control box connect
trough your wireless router to communicate to each other. Your internet connection will
work normally on your smart device using this connection method. This method is also
recommended when controlling multiple control boxes so that you can communicate
with all control boxes at the same time.
6. If you are connecting multiple Illuminate™ control boxes to your smart device, see the
Advanced Illuminate™ features section on Page 17. If you want to start the Setup Wizard
again, go to the Help Screen.
Figure 3a: Home Screen with
one Control Box
7. The Illuminate™ starter kit(s) will appear in the home screen. Press on box to right to
select the starter kit to control and an "Enter" box will appear, then tap Enter to control the
Illuminate™ string. Each function screen is demonstrated in the Using Illuminate section,
starting on page 7.
◊ NOTE: Before pressing the enter button you can rename the control box by
pressing on the control box name and holding your finger there until the submenu
comes up allowing you to rename the control box.
Illuminate™
Rev 082015
Figure 3: Home Screen
www.seasonalspecialties.com
Figure 3b: Home Screen with
multiple Control Boxes
Page 6 of 26