Advertisement
5. Install the PCB into the metal can:
a. Screw the PCB stand-off to the metal can via the hole in the bottom of the can (77).
77
b. Fasten the zip ties around each of the cables on the inside of the tin (78). This acts as a
strain relief and protects the solder connections. Press the tie snug against the can interior,
and pull the tail as tight as it will go (78). Trim off the tail with your snips (79).
78
6. Add stickers:
a. Clean the lid of the can, inside and out, with alcohol.
b. Place the serial number sticker on the inside of the lid (80,81).
80
79
81
25
Advertisement
