Advertisement
b. Solder the XLR cable to the PCB (71,72,76). The red goes to the hole labeled XLR3 and
the white wire goes to the hole labeled XLR2 The copper shield wire goes in the round hole
labeled XLR1.
71
c. Slide the piezo disc cable through the other grommet (73). Solder the red wire to the hole
labeled PZ1. Solder the white wire to PZ2. Solder the shield of the cable to ground: use a
pad from either R2 or R7, in the corner of the PCB. Use whichever is closest (76).
73
75
4. At this point take a break from assembly, and set the bias by following the steps in the section
"SETTING THE BIAS" on page 30. After the bias is set, continue on from here to the end of
the section.
72
74
76
24
Advertisement
